After uploading the bot, my pv8 was 24×7 flooded with messages on how to use it. Well, its a little diffrent from other bots, coz this on is not shit !!
Nobody likes f#@king useless talks, so lets move to tutorial part.
Before moving forward just have a look on above pics, might some brilliant ppl like me can catch how to use it :-D .
NOTE :- All commands are sent to the master id (the id you are using in tool) in above pic master id is -=nuke-bot=- so commands are to be sent to this id and not to “ANY” other id.
Below are some steps so just go through it,
Fill up the tool as show in above pic.
Send an add req to master id after logging it.
Master id should accept your add.
Send bot password (Not id’s password, its written bot’s password) to its pv8, it should reply you with “Your ID is added to master list!”.
Everything is now setup. Now send help and go on!
Send call#id#pass#room to get some bot id in your room (id must be admin), and do not use same master id to enter in room, for my case i will try to call any id other then -=nuke-bot=-
Once id is in room, you can operate it by sending commands to master id’s pv8(NOTE it again, you have to send commands to master id not the id in room, its useless id, whaterver command you send..send it to master id..again making you remember that for my case master id is -=nuke-bot=-)
Nothing to write here :-D , coz you are done!
Last thing, hang#id#pass#room#message this command will hang id in room, but for some reasons message sending speed it a little fast so remove #message part from above command, so your command should look like, hang#id#pass#room
[center]